﻿GET_GEVOMechL2_09_01_01_45 - STEP-BY-STEP Cont Screen
1
00:00:00,000 --> 00:00:09,542
<b>Warning:</b> Before rotating the crankshaft with the barring-over device, always check that all personnel and tooling are safely clear of engine movement.

2
00:00:09,542 --> 00:00:16,667
25. Replace the two rotor support and alignment guide pins with flex plate-to-alternator rotor bolts.

3
00:00:16,667 --> 00:00:25,917
26. Install the remaining 22 flex plate to alternator rotor bolts in a 10-point pattern and tighten the bolts with an air ratchet.

4
00:00:25,917 --> 00:00:34,417
<b>Warning:</b> Improper handling of the hydraulic wrenches or use of an incorrect reaction arm may result in serious injury or death.

5
00:00:34,417 --> 00:00:40,083
Follow all tool manufacturer safety procedures when operating these tools.

6
00:00:40,083 --> 00:00:56,458
27. Torque all 30 flex plate to alternator rotor bolts in a 10-point pattern to 367 ± 37 lb.-ft. (498 ± 50 Nm).

7
00:00:56,458 --> 00:01:03,417
<b>Caution:</b> To prevent damage to the alternator, do not leave the rotor support installed with loose bolts.

8
00:01:03,417 --> 00:01:13,000
28. Unbolt the rotor support, allowing it to drop to the platform beneath the alternator, then remove the rotor support from beneath the alternator.

9
00:01:13,000 --> 00:01:17,708
29. Install the alternator guards to both sides of the engine.

10
00:01:17,708 --> 00:01:28,167
<b>Note:</b> Leave the barring over motor installed and crankcase inspection covers removed to support tasks now required to align the alternator to the engine.
