﻿GET_GEVOMechL2_09_01_01_37 - STEP-BY-STEP Cont Screen
1
00:00:00,000 --> 00:00:08,830
9. Apply WD40 or other rust inhibitor to the polished areas and wipe down with a clean dry cloth.

2
00:00:08,830 --> 00:00:19,708
<b>Caution:</b> Failure to properly clean and lubricate the flywheel-rotor yoke fit can result in an improper coupling that forces the alternator bearing out of its housing.

3
00:00:19,708 --> 00:00:26,208
10. Apply Lubriplate<sup>®</sup> 630AA to the following surfaces.

4
00:00:26,208 --> 00:00:36,292
Alternator top flange bolt holes, jack bolt hole threads, and dowel alignment holes, including the back side washer mounting surfaces.

5
00:00:36,292 --> 00:00:39,125
Torsion bar washer load surfaces.

6
00:00:39,125 --> 00:00:43,930
Flex plate to alternator rotor bolt hole threads and rabbet fit.

7
00:00:43,930 --> 00:00:57,375
<b>Caution:</b> When the rotor support and alignment guide pins (GPM060) are not used and the alternator is not completely square with the flex plate, the coupling bolts can often be difficult to get started.

8
00:00:57,375 --> 00:01:08,375
<b>Caution:</b> Failure to fully apply the guide pins until no threads are showing may result in damage to the crank sensor box while barring the engine to apply the coupling bolts.

9
00:01:08,375 --> 00:01:21,708
11. Install two rotor support and coupling alignment guide pins (GPM060) in the fourth bolt holes to the left and right of the 12 o’clock position in the flex plate-to-alternator rotor.