﻿GET_GEVOMechL2_09_01_01_26 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:04,458
Typical steps to resurface the collector rings are as follows:

2
00:00:04,458 --> 00:00:13,917
1. With the engine shut off, gain access to the brush and collector ring area by removing the top cover from the brush holder/collector ring cover.

3
00:00:13,917 --> 00:00:17,792
2. Remove the stone from the packaging.

4
00:00:17,792 --> 00:00:23,667
The stone should be of medium coarseness (Grainger item number 3GD69).

5
00:00:23,667 --> 00:00:30,333
3. Cut off a one-inch long section of the stoning material using a hacksaw and a vise.

6
00:00:30,333 --> 00:00:36,917
<b>Note: </b>Additional sections of stone material may be cut if more than one collector ring needs resurfacing.

7
00:00:36,917 --> 00:00:42,375
4. Lift up the brush assembly on the collector ring that needs resurfacing.

8
00:00:42,375 --> 00:00:46,417
Set the brush off to the side without disconnecting the wires.

9
00:00:46,417 --> 00:00:58,042
5. Set the cut piece of stone down inside the brush holder, place the brush back on top of the piece of stone, and reposition the tensioning clip on top of the brush assembly.

