﻿GET_GEVOMechL2_09_01_01_23 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:05,500
Typical steps to install the brush holder cover hose and clamps are as follows:

2
00:00:05,500 --> 00:00:10,042
1. Position the hose onto the upper flange pipe.

3
00:00:10,042 --> 00:00:19,458
2. While holding the hose in place, tighten the clamp using a correctly sized nut driver or a straight blade screwdriver with a heavy spade.

4
00:00:19,458 --> 00:00:24,250
<b>Note: </b>Repeat the step with the brush holder cover end of the hose.

5
00:00:24,250 --> 00:00:31,333
3. Attempt to twist the hose and if it moves, tighten the clamp until it is secured on both ends.

6
00:00:31,333 --> 00:00:39,875
<b>Note: </b>The clamp should be torqued to 1.0-1.5 lb.-ft. (1.4-2.0 Nm).

