﻿GET_GEVOMechL2_09_01_01_20 - STEP-BY-STEP Cont Screen
1
00:00:00,000 --> 00:00:02,583
5. Remove the shim.

2
00:00:02,583 --> 00:00:09,583
6. Install the bus ring bolts and washers that hold the bus rings to the brush holders.

3
00:00:09,583 --> 00:00:17,875
7. Torque the bus ring bolts to 22-24 lb.-ft. (30-33 Nm).

4
00:00:17,875 --> 00:00:25,208
<b>Note: </b>The large diameter washers are assembled on the 10:30 and 12 o’ clock brush holder stud positions.

5
00:00:25,208 --> 00:00:31,500
8. Install the brushes as discussed in the Brush Installation section of this module.

6
00:00:31,500 --> 00:00:35,542
<b>Note: </b>Each brush must ride in the center of the collector ring.

7
00:00:35,542 --> 00:00:45,083
If it does not, adjust the location of the brush holder on the stud as discussed in the Brush Holder and Stud Assembly Installation section of this module.
