﻿GET_GEVOMechL2_09_01_01_19 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:04,792
Typical steps to align the brush holder and stud assembly are as follows:

2
00:00:04,792 --> 00:00:10,167
<b>Note:</b> The brush holder to stud clamp must not be loosened during this process.

3
00:00:10,167 --> 00:00:18,208
1. Assemble the brush holder and stud assembly to the brush holder yoke but do not tighten the mounting bolt.

4
00:00:18,208 --> 00:00:30,833
2. Place a 0.089-0.091 inch (2.2-2.3 mm) thick fiberboard shim between the brush holders and the collector rings.

5
00:00:30,833 --> 00:00:37,750
3. Slide the brush holder against the fiberboard shim and tighten the brush holder stud mounting bolt.

6
00:00:37,750 --> 00:00:50,167
4. Torque the mounting bolt to 165-185 lb.-ft. (223.7-250.8 Nm).

