﻿#VALUE!
1
00:00:00,000 --> 00:00:14,792
20. Verify that a bead of the approved sealant is visible at the joints after the bolts have been torqued and that a bead of sealant is visible around the pinion end armature bearing cap, and that the armature bearing cap overboard drain slots are free of sealant.

2
00:00:14,792 --> 00:00:26,083
<b>Warning:</b> The traction motor, wheels, and axle assembly weighs approximately 12,000 lbs. (5,443 kg).

3
00:00:26,083 --> 00:00:30,583
Ensure that the crane and cables are adequate to lift and move the assembly.

4
00:00:30,583 --> 00:00:40,917
<b>Warning:</b> When the traction motor, wheel, and axle assembly is lifted, the U-tube will quickly rotate to the open-end up position, and could injure nearby personnel.

5
00:00:40,917 --> 00:00:49,333
Therefore, as the assembly is being lifted, support the assembly by allowing the U-tube to turn slowly to the open-end up position.

6
00:00:49,333 --> 00:01:02,583
21. Attach a nylon lifting strap to each axle journal bearing, then lift the traction motor, axle, and wheel assembly and rotate 90° to return the traction motor combo to the horizontal position.

7
00:01:02,583 --> 00:01:13,750
22. After the 24 hours sealant cure time is over, apply D50E25C gear oil or equivalent to the gear case.

8
00:01:13,750 --> 00:01:21,792
<b>Note:</b> The initial fill capacity of the gear case is 9 quarts (8.5 liters).

9
00:01:21,792 --> 00:01:39,625
23. Check the gear case lubricant level using a dipstick (Part Number 41C637237G1), then install and torque all pipe plugs to 100 to 110 lb.-ft. (136 to 150 Nm).

10
00:01:39,625 --> 00:01:44,917
24. Apply a safety lock wire to the fill plug and the drain plug.

11
00:01:44,917 --> 00:01:54,917
<b>Note:</b> The gear case oil level should never be more than 1.75 inches (44 mm) below the bottom of the fill opening.

12
00:01:54,917 --> 00:02:05,167
One quart (1 L) of oil will raise the oil level by approximately 0.375 inches (10 mm).
