﻿GET_GEVOMechL2_08_01_01_80 - STEP-BY-STEP Cont Screen
1
00:00:00,000 --> 00:00:10,750
10. Install the bottom half of the gear case, ensuring that the gear case groove engages with the bearing cap lip and the inner and outer axle seals in the gear case opening.

2
00:00:10,750 --> 00:00:22,375
11. Mount a washer or washer assembly on a 12-point flanged 1.00-8 bolt, then install the first gear case mounting bolt and washer assembly as follows:

3
00:00:22,375 --> 00:00:44,417
a. If a Nord lockwasher is used, lubricate the threads of the gear case mounting bolt and both faces of the washer with a Wabtec approved Moly-based lubricant (84B565364A1) and wait until dry to touch (approximately 5 minutes) before assembly, and then install the bolt and washer in the top hole and hand tighten.

4
00:00:44,417 --> 00:00:52,750
b. If a solid washer assembly is used, without lubrication, install the bolt and washers in the top hole and hand tighten.

5
00:00:52,750 --> 00:01:09,417
c. If a 4-component load washer/spacer assembly is used, without lubrication and while ensuring that the chamfered (colored) side of the load washer is against the bolt head, install the bolt and washers/spacer assembly in the top hole and hand tighten.

6
00:01:09,417 --> 00:01:29,500
12. On the top gear case half, apply a 0.13-inch (3.2-mm) maximum bead of the approved sealant along the engine joint face between the gear case halves and do not allow the approved sealant within 1 inch (25.4 mm) of the split line bolt holes.

7
00:01:29,500 --> 00:01:34,667
<b>Note:</b> Be careful to keep the sealant away from the gear case bolt holes.
