﻿GET_GEVOMechL2_08_01_01_78 - STEP-BY-STEP Cont Screen
1
00:00:00,000 --> 00:00:14,875
4. Clean the surfaces of the wheel and gear hubs on which the wheel-side gear case seal (gutter) rides, then lubricate these surfaces with D50E25C gear oil or equivalent.

2
00:00:14,875 --> 00:00:23,417
5. Install the wheel-side axle seal to the axle assembly with the lip of the seal located over the wheel gear and gear hubs.

3
00:00:23,417 --> 00:00:34,417
<b>Note:</b> The latch should be located on the left (bottom half of the gear case), and the cut-out notch should be located on the right (top half of the gear case).

4
00:00:34,417 --> 00:00:44,417
6. Add a 0.25-inch (6.4-mm) minimum bead of the approved sealant in the groove and latch the seal.

5
00:00:44,417 --> 00:00:58,417
7. Add a 0.25-inch (6.4-mm) maximum bead of the approved sealant to the joint where the latch occurs, ensuring that all sealing surfaces are not pinched or folded.
