﻿1
00:00:00,000 --> 00:00:05,458
Typical steps to remove the U-tube, wheels, and axle are as follows: 

2
00:00:05,458 --> 00:00:14,333
1. Remove the gear case as discussed in the DC Traction Motor Combo: Gear Case Disassembly section of this module. 

3
00:00:14,333 --> 00:00:21,375
2. Remove the two bolts, plate, and cable cleat holding the traction motor cables to the U-tube. 

4
00:00:21,375 --> 00:00:27,042
3. Remove the eight bolts that hold the U-tube to the traction motor frame. 

5
00:00:27,042 --> 00:00:35,375
4. If equipped, remove the two 5/8-inch bolts (or drain hole plugs) from the middle of the U-tube. 

6
00:00:35,375 --> 00:00:40,625
<b>Note:</b> While removing the traction motor bolts, check the bolt head for the bolt grade. 

7
00:00:40,625 --> 00:00:46,000
Discard all grade 5 bolts and replace them with grade 8 bolts. 

8
00:00:46,000 --> 00:00:53,625
5. Attach lifting cables around both ends of the wheels, gear, axle, and U-tube assembly.
