﻿1
00:00:00,000 --> 00:00:07,792
16. Remove the guide pins and install the mounting bolts (one at a time), then hand-tighten the bolts. 

2
00:00:07,792 --> 00:00:25,500
17. Torque the gear case-to-motor and gear case-to-U-tube bolts to the proper value, then, to seal out moisture, apply DOW 832 sealant to the open end of the threaded through holes for the gear case mounting bolts, completely filling the end of the bolt holes. 

3
00:00:25,500 --> 00:00:40,375
<b>Note:</b> On gear cases equipped with inspection covers, clean the cover and (without gasket) apply a 0.125-inch (3.2-mm) bead of DOW 832 sealant around and between the bolt holes. 

4
00:00:40,375 --> 00:00:46,333
Install the cover, torque the bolts to the proper value, and apply a safety lock wire. 

5
00:00:46,333 --> 00:00:58,083
<b>Warning:</b> The motor, wheels, gear case, and axle assembly weighs approximately 13,270 lbs. (6,019 kg). 

6
00:00:58,083 --> 00:01:02,958
Ensure that the crane and cables are adequate to lift and move the assembly. 

7
00:01:02,958 --> 00:01:15,958
18. Attach a lifting strap to each axle journal bearing, then lift the traction motor, axle, and wheels assembly and rotate 90° to return the traction motor combo to the horizontal position.
