﻿1
00:00:00,000 --> 00:00:12,875
14. Use C-clamps on the split line flanges at the gear case ends to draw the halves together evenly, then position C-clamps near the gear case center line to prevent misalignment. 

2
00:00:12,875 --> 00:00:17,375
15. Fasten the gear case halves as follows: 

3
00:00:17,375 --> 00:00:25,875
a. Install one split line bolt and washer at the axle end, then draw the gear case halves together but do not tighten. 

4
00:00:25,875 --> 00:00:35,708
<b>Note:</b> While the gear case is closing, ensure that the pinion end is properly engaging the pinion bearing cap by viewing the process at the open end. 

5
00:00:35,708 --> 00:00:42,083
b. Install and hand-tighten a second bolt and washer on the motor side axle end. 

6
00:00:42,083 --> 00:00:48,875
c. Install and hand-tighten a third bolt and washer between the axle and pinion bores.
