﻿GET_GEVOMechL2_08_01_01_63 - STEP-BY-STEP Cont Screen
1
00:00:00,000 --> 00:00:14,792
11. Remove the adhesive backing from the Gortex tape (Part Number 41E903878P32) and apply the tape to the center bolt pad between the axle bore and pinion bore on the upper gear case half.

2
00:00:14,792 --> 00:00:28,792
12. On the top gear case half, apply a 0.125-inch (3.18-mm) bead of sealant along the entire split line surface, just inside the bolt holes.

3
00:00:28,792 --> 00:00:36,792
<b>Warning:</b> The top gear case half weighs approximately 150 lbs. (68 kg).

4
00:00:36,792 --> 00:00:41,375
Ensure that the crane and cables are adequate to lift and move the assembly.

5
00:00:41,375 --> 00:00:50,750
<b>Caution:</b> Before installing the upper gear case half, inspect the pinion bore seal to verify that the seal has not bulged out of the groove.

6
00:00:50,750 --> 00:00:56,000
If it has, remove the bottom gear case half and reseat the pinion seal.

7
00:00:56,000 --> 00:01:11,958
13. Install the top half of the gear case, then verify engagement of the gear case leg with the groove in the motor pinion end bore seal, and the motor-side and wheel-side axle seals (gutters) with the gear case opening.
