﻿GET_GEVOMechL2_08_01_01_56 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:05,708
Typical steps to install the U-tube, wheels, and the axle are as follows:

2
00:00:05,708 --> 00:00:17,375
1. Clean the traction motor frame and U-tube mounting surfaces with a rag dipped in an approved solvent, then wipe the mounting surfaces with a clean rag to remove excess solvent.

3
00:00:17,375 --> 00:00:31,375
2. Clean the mating surface and apply a gasket (Part Number 41A239176P317) at the pinion end (PE) of the traction motor, where the U-tube and the motor frame join.

4
00:00:31,375 --> 00:00:46,083
3. Clean the mating surface and apply a gasket (Part Number 41A239176P317) at the connection end (CE) of the traction motor, where the U-tube and the motor frame join.

5
00:00:46,083 --> 00:00:52,083
4. Clean the pinion end bearing cap groove with CRC Natural Degreaser.
