﻿1
00:00:00,000 --> 00:00:12,583
<b>Caution:</b> If a high-pressure spray washer is used to clean the U-tube, wheels, gear, and axle assembly, use extreme care to ensure that the spray does not enter the bearings. 

2
00:00:12,583 --> 00:00:15,708
Do NOT submerge the assembly in liquid. 

3
00:00:15,708 --> 00:00:22,792
5. Thoroughly clean the U-tube, wheels, gear, and axle assembly of grease and dirt. 

4
00:00:22,792 --> 00:00:33,708
6. After cleaning, apply rust prohibitive to all machined surfaces except the wheels, then cover the assembly in plastic and tape shut until needed. 

5
00:00:33,708 --> 00:00:40,000
7. Install guide pins in the bearing cap before removing all the bolts. 

6
00:00:40,000 --> 00:00:47,958
<b>Caution:</b> Use the guide pins to keep the alignment of the inner bearing and gasket while the bearing cap is removed. 

7
00:00:47,958 --> 00:00:53,917
Failure to use guide pins results in misalignment of the inner bearing housing and gasket. 

8
00:00:53,917 --> 00:00:58,625
8. Remove the pinion end bearing cap from the traction motor.
