﻿1
00:00:00,000 --> 00:00:09,042
<b>Note:</b> The traction motor combo must be removed from the truck and placed on level ground before the gear case can be removed. 

2
00:00:09,042 --> 00:00:13,417
Typical steps to disassemble the gear case are as follows: 

3
00:00:13,417 --> 00:00:22,167
1. Drain the lubricant from the gear case by removing the drain plug located on the lower side of the gear case bottom half. 

4
00:00:22,167 --> 00:00:29,417
2. Remove the 16 gear case split line bolts and washers and the two gear case mounting bolts. 

5
00:00:29,417 --> 00:00:36,917
<b>Warning:</b> The upper gear case weighs approximately 150 lbs. (68 kg). 

6
00:00:36,917 --> 00:00:41,792
Ensure that the crane and cables are adequate to lift and move the gear case. 

7
00:00:41,792 --> 00:00:52,583
3. Attach a lifting cable through the inverted "U-shaped" holes in each end of the upper gear case, and take up the slack in the cables with a hoist or crane. 

8
00:00:52,583 --> 00:01:05,125
4. With an overhead crane, lift off the upper gear case, guiding the center bolt pad, located between the axle and pinion bores, through the relief in the traction motor framehead.
