﻿1
00:00:00,000 --> 00:00:11,375
18. Apply C-clamps on each wheel rim below each side of the axle journal bearing housing to prevent the housing from rotating during traction motor combo removal. 

2
00:00:11,375 --> 00:00:19,000
19. Raise the traction motor nose up to clear the nose suspension or the truck frame as the traction motor is lowered. 

3
00:00:19,000 --> 00:00:28,792
20. Support the traction motor nose with blocks suitably placed under the frame, such that it cannot slip off if the traction motor moves or rotates. 

4
00:00:28,792 --> 00:00:46,292
21. Lower the drop table until the space between the top of the axle journal bearing housing and the truck frame is approximately 7 inches (175 mm), then tighten the coil spring retaining straps to remove any remaining slack.
