﻿1
00:00:00,000 --> 00:00:10,375
14. In a DC traction motor, check the suspension lugwear plates on the traction motor and, if excessively worn, replace the plates. 

2
00:00:10,375 --> 00:00:24,917
15. Lower the drop table by approximately 5 inches (125 mm), place chocks over the rail, and nip the securing bolts to secure the traction motor combo in place. 

3
00:00:24,917 --> 00:00:33,042
16. Raise the drop table by 2 inches (50 mm) to compress the coil springs. 

4
00:00:33,042 --> 00:00:53,875
17. For the four coil springs at the traction motor combo, place a spring retaining strap around the truck frame, under the air piping and through the spring coils at approximately the fifth coil, then join the strap ends, leaving at least 12 inches (300 mm) of slack in the straps. 

5
00:00:53,875 --> 00:01:06,625
<b>Note:</b> Verify that the wooden blocks and hydraulic jacks supporting the truck frame are securely in place if the combo to be removed is in positions 1, 3, 4, or 6.
