﻿GET_GEVOMechL2_07_01_01_73 - STEP-BY-STEP Cont Screen
1
00:00:00,000 --> 00:00:08,917
9. Disconnect the hoses for the flange lubricators if used, and cover the opening to prevent the entry of foreign materials.

2
00:00:08,917 --> 00:00:14,875
10. Disconnect the hand brake chain if the long-hood end truck is being removed.

3
00:00:14,875 --> 00:00:21,250
11. Remove the lateral and yaw dampers from the platform and save the hardware.

4
00:00:21,250 --> 00:00:29,167
12. Remove both safety hooks from the truck frame, mark as right or left, and save the hardware.

5
00:00:29,167 --> 00:00:45,792
<b>Warning: </b>The locomotive weighs approximately 440,000 lbs. (199581 kg) and the truck weighs approximately 62,000 lbs. (28123 kg).

6
00:00:45,792 --> 00:00:49,875
Ensure that the lifting or jacking device is adequate.

7
00:00:49,875 --> 00:00:58,208
13. Raise the locomotive platform clear of the truck with jacks or a crane, or lower the truck on a drop table.

8
00:00:58,208 --> 00:01:03,917
<b>Note: </b>Ensure that the cables, air ducts, and hoses are not damaged.

9
00:01:03,917 --> 00:01:13,958
If the truck is to be pulled out sideways, the locomotive platform must be raised, or the truck lowered, at least 10 inches (254 mm).

10
00:01:13,958 --> 00:01:26,125
14. After the truck is removed from under the locomotive, cover the truck center pin bearing and traction motor openings to prevent contamination with dirt and other foreign materials.
