﻿GET_GEVOMechL2_07_01_01_34 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:04,208
Typical steps to replace the lateral liners are as follows:

2
00:00:04,208 --> 00:00:15,833
1. At the pin retainer assembly, remove the bolts, the hardened washers, and the journal box retainer pin from the truck frame, then save the hardware for re-assembly.

3
00:00:15,833 --> 00:00:20,000
2. Remove both journal box retainer pins.

4
00:00:20,000 --> 00:00:25,083
<b>Note: </b>The end journal box tee pins are shorter than the center tee bolts.

5
00:00:25,083 --> 00:00:26,958
Do not mix them.

6
00:00:26,958 --> 00:00:33,333
3. The liners should fall out but, if not, remove them with an appropriate tool.

7
00:00:33,333 --> 00:00:39,250
<b>Note:</b> A hydraulic ram may be used to laterally remove the motor combo.

8
00:00:39,250 --> 00:00:45,250
4. Position the new liners in place and return the correct tee bolts.

9
00:00:45,250 --> 00:00:51,833
<b>Note:</b> The lateral liners on each end axle are similar on the inboard and outboard sides.

10
00:00:51,833 --> 00:00:54,917
The liners on the central axles are different.

11
00:00:54,917 --> 00:00:56,833
Do not mix them.

12
00:00:56,833 --> 00:01:05,958
5. Re-install the pin retainer assembly, with the raised portion toward the truck frame, and fasten using the previously saved hardware.

13
00:01:05,958 --> 00:01:16,167
6. Torque the retainer assembly bolts to 58 ± 3 lb.-ft. (80 ± 5 Nm).