﻿GET_GEVOMechL2_06_01_01_62 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:05,500
Typical steps to remove the high adhesion truck from under the locomotive are as follows:

2
00:00:05,500 --> 00:00:13,917
1. Chock at least two sets of truck wheels on both trucks to prevent the locomotive from rolling in either direction.

3
00:00:13,917 --> 00:00:21,542
2. Release the hand brake if set, and allow time for the truck wheels to seat against the wheel chocks.

4
00:00:21,542 --> 00:00:29,542
<b>Warning: </b>Ensure that the truck wheels are chocked and release the hand brake before cutting out the brake cylinder air.

5
00:00:29,542 --> 00:00:33,625
Ensure that air is cut out to only one truck at a time.

6
00:00:33,625 --> 00:00:44,042
Unexpected motion can occur if the wheels are not chocked, if the hand brake is set when brake air is released, or if the air is cut off to both trucks at one time.

7
00:00:44,042 --> 00:00:49,000
Unexpected rolling of the locomotive can cause serious injury or death.

8
00:00:49,000 --> 00:00:57,250
3. With the locomotive secure, locate and close the truck air cut-out cock on the underside of the locomotive frame.

9
00:00:57,250 --> 00:01:01,875
<b>Note:</b> Close only the truck cut-out cock for the truck being removed.

10
00:01:01,875 --> 00:01:09,167
Disconnect the hose to that truck's brake cylinders only after all air has been exhausted from the truck air lines.




