﻿GET_GEVOMechL2_06_01_01_55 - ANIMATION Screen
1
00:00:00,000 --> 00:00:18,125
<b>Warning:</b> The AC traction motor combo weighs approximately 13,270 lbs. (6,019 kg), and the DC traction motor combo weighs approximately 12,000 lbs. (5,443 kg).

2
00:00:18,125 --> 00:00:22,708
Ensure that an adequate crane and cables are used to lift and move the combo.

3
00:00:22,708 --> 00:00:31,250
<b>Warning:</b> Disconnect the MU jumper cables connecting the locomotive being serviced to any other equipment prior to performing any maintenance tasks. 

4
00:00:31,250 --> 00:00:35,500
Hazardous voltages may be present between interconnected units. 

5
00:00:35,500 --> 00:00:41,917
Failure to disconnect the MU jumper cables from the locomotive being serviced may result in injury or death.

6
00:00:41,917 --> 00:00:52,792
<b>Warning:</b> To ensure the safety of personnel, before proceeding, ensure that the truck and locomotive are securely supported and that the electrical power to the traction motors is OFF.

7
00:00:52,792 --> 00:01:00,875
<b>Warning:</b> On AC locomotives, capacitors in the inverter circuits may not be fully discharged and may contain lethal voltages.

8
00:01:00,875 --> 00:01:10,333
Before performing any maintenance on a traction motor or traction motor power cables, open the auxiliary cab door and raise the barrier bar to the vertical position.

9
00:01:10,333 --> 00:01:13,417
Raising the barrier bar closes the CDS.

10
00:01:13,417 --> 00:01:18,333
Wait until all lights on the CDI are extinguished before proceeding with any maintenance.

11
00:01:18,333 --> 00:01:31,708
<b>Caution:</b> If the gear case is filled with oil, it cannot be tilted more than 4 inches (102 mm) end to end from horizontal because the oil will run around the seals and drain into the traction motor.

12
00:01:31,708 --> 00:01:35,042
Use a three-point lift to lift the combo.