﻿GET_GEVOMechL2_06_01_01_54 - STEP-BY-STEP Cont Screen
1
00:00:00,000 --> 00:00:09,208
22. Lower the drop table until the traction motor combo clears the truck and remove any remaining truck pedestal liners.

2
00:00:09,208 --> 00:00:14,917
23. Move the traction motor combo from beneath the truck and locomotive.

3
00:00:14,917 --> 00:00:29,167
<b>Caution:</b> If the gear case is still filled with oil, it cannot be tilted more than 4 inches (102 mm) end to end from horizontal because the oil will run around the seals and drain into the traction motor.

4
00:00:29,167 --> 00:00:47,750
<b>Warning:</b> The AC traction motor combo weighs approximately 13,270 lbs. (6,019 kg), and the DC traction motor combo weighs approximately 12,000 lbs. (5,443 kg).

5
00:00:47,750 --> 00:00:53,792
Ensure that an adequate crane and cables are used to lift and move the traction motor combo.

6
00:00:53,792 --> 00:01:04,667
24. Using a suitable hoist, lift the traction motor combo from the drop table and move it to the area assigned for cleaning, maintenance, or storage.

7
00:01:04,667 --> 00:01:14,125
25. Set the traction motor frame in the normal horizontal position on blocks high enough so that the wheels clear the floor.

8
00:01:14,125 --> 00:01:29,667
<b>Caution:</b> After the combo is removed from the truck, if it is not broken down immediately, the rotor (on the AC motor) or armature (on the DC motor) should be locked to prevent possible shipping damage to bearings in the motor.

