﻿GET_GEVOMechL2_06_01_01_51 - STEP-BY-STEP Cont Screen
1
00:00:00,000 --> 00:00:05,708
13. Remove the DC traction motor nose suspension as follows:

2
00:00:05,708 --> 00:00:15,625
a. Jack or lift the traction motor nose to compress the suspension assembly approximately 0.5 inches (13 mm).

3
00:00:15,625 --> 00:00:28,083
b. Install a 1/2-13 x 6.5 inch (165 mm) long bolt and nut between the U-channels on both sides of the suspension assembly.

4
00:00:28,083 --> 00:00:37,542
c. Tighten the nuts to compress the suspension assembly to 11.7 inches (297 mm) or less.

5
00:00:37,542 --> 00:00:47,792
d. Lower the traction motor slightly, then remove the cotter pins and retaining pins that secure the vertical keeper pins in the suspension assembly.

6
00:00:47,792 --> 00:00:55,458
<b>Note:</b> The vertical keeper pins should drop out of the suspension assembly when the retaining pins are removed.

7
00:00:55,458 --> 00:01:02,375
e. Slide the suspension assembly sideways, removing the assembly from the truck frame.

8
00:01:02,375 --> 00:01:18,792
f. Inspect the traction motor nose suspension assembly for separation of laminations, badly eroded rubber laminations, or cracked or broken cast members and, if defective, remove and replace the traction motor nose suspension assembly.


