﻿GET_GEVOMechL2_06_01_01_32 - STEP-BY-STEP Cont Screen
1
00:00:00,000 --> 00:00:03,708
c. Inspect for damage to rubber.

2
00:00:03,708 --> 00:00:22,958
<b>Note: </b>Cuts or splits in rubber surfaces are acceptable if length of damage does not exceed 2 inches (51 mm), depth of damage does not exceed 1/2 inch (13 mm), and no more than two cuts or splits occur on any one side of a single lamination.

3
00:00:22,958 --> 00:00:27,333
d. Inspect for oil and grease contamination.

4
00:00:27,333 --> 00:00:43,792
<b>Note: </b>Some softening of the rubber surface from contamination is acceptable, but the loadbearer should be replaced if swelling increases the length or width of a rubber lamination 1/4 inch (6.4 mm) greater than normal.

5
00:00:43,792 --> 00:00:48,917
4. Replace any defective or displaced loadbearers.



