﻿GET_GEVOMechL2_04_01_01_16 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:04,042
Typical steps to install new filter elements are as follows:

2
00:00:04,042 --> 00:00:13,167
<b>Note:</b> Wipe a small amount of clean lubricating oil on the O-rings on all new fuel filter sections to prevent O-ring damage during assembly.

3
00:00:13,167 --> 00:00:17,500
1. Install new approved filter elements.

4
00:00:17,500 --> 00:00:24,625
2. Check the condition of the O-ring seal on each filter tank door and replace the O-ring, if needed.

5
00:00:24,625 --> 00:00:31,000
3. Close and seal the filter tank doors and ensure that the vent valve is closed.

6
00:00:31,000 --> 00:00:34,958
4. Close the fuel filter drain valve.

7
00:00:34,958 --> 00:00:42,250
5. Place the locomotive in Self-Test 300 and prime the fuel system for five minutes.

8
00:00:42,250 --> 00:00:49,750
6. Start the engine, inspect the entire fuel system for leaks, and make corrections as necessary.



