﻿GET_GEVOMechL2_03_01_01_99 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:04,167
Typical steps to install the radiator shutter are as follows:

2
00:00:04,167 --> 00:00:15,083
<b>Warning:</b> To prevent personal injury and potential equipment damage, ensure that the engine cannot be started before removing, installing, or adjusting any components.

3
00:00:15,083 --> 00:00:18,250
Open the BS to prevent starting attempts.

4
00:00:18,250 --> 00:00:23,625
Also, place the FPB, the LCCB in the OFF position.

5
00:00:23,625 --> 00:00:27,125
Apply a warning tag to the EC switch.

6
00:00:27,125 --> 00:00:37,000
1. Attach a proper lifting device to the attachment holes located on the end plates, then carefully lift the shutter and set it in place.

7
00:00:37,000 --> 00:00:46,500
2. Install and fasten the shutter to the radiator using the previously removed and saved bolts, washers, and lockwashers.

8
00:00:46,500 --> 00:00:54,208
3. Connect the air lines attached to the shutter cylinders following the labels applied at the time of removal.

9
00:00:54,208 --> 00:01:00,250
<b>Note:</b> Check the radiator shutter air lines to ensure the proper tap blocks are installed.

10
00:01:00,250 --> 00:01:10,833
If the radiator tap blocks are missing, install the two shutter airline brackets, then install the radiator shutter air lines such that the air lines are at a downward angle.

11
00:01:10,833 --> 00:01:16,500
Refer to site specific maintenance instructions for specific details and part numbers.

12
00:01:16,500 --> 00:01:27,167
4. Install and fasten the walkway cover using the previously removed and saved hex-head bolts, washers, and lockwashers.
