﻿GET_GEVOMechL2_03_01_01_75 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:04,000
Typical steps to remove the radiator shutter are as follows:

2
00:00:04,000 --> 00:00:14,958
<b>Warning:</b> To prevent personal injury and potential equipment damage, ensure that the engine cannot be started before removing, installing, or adjusting any components.

3
00:00:14,958 --> 00:00:18,167
Open the BS to prevent starting attempts.

4
00:00:18,167 --> 00:00:23,417
Also, place the FPB, the LCCB in the OFF position.

5
00:00:23,417 --> 00:00:26,375
Apply a warning tag to the EC switch.

6
00:00:26,375 --> 00:00:33,708
<b>Warning:</b> If the locomotive is equipped with AESS, the diesel engine may start without operator action.

7
00:00:33,708 --> 00:00:37,750
Exercise caution when working around the radiator cab.

8
00:00:37,750 --> 00:00:43,875
Ensure that AESS is disabled before performing any maintenance procedures on the locomotive.

9
00:00:43,875 --> 00:00:49,042
Failure to do so may result in death or serious personal injury.

10
00:00:49,042 --> 00:00:57,250
1. Remove and save the hex-head bolts, washers, and lockwashers, then remove the walkway cover.

11
00:00:57,250 --> 00:01:02,542
2. Place the walkway cover in an area where it will not be damaged.

12
00:01:02,542 --> 00:01:08,375
<b>Note:</b> The air lines should be labeled before they are removed from the shutter cylinders.

13
00:01:08,375 --> 00:01:13,583
This will ensure that they will not be reversed when re-installing the shutters.

14
00:01:13,583 --> 00:01:20,208
3. Disconnect the air lines, two per shutter, attached to the shutter cylinders.

15
00:01:20,208 --> 00:01:28,125
4. Remove and save all bolts, washers, and lockwashers that hold the shutter to the radiator.

16
00:01:28,125 --> 00:01:37,167
5. Attach a proper lifting device to the attachment holes located on the end plates, then carefully remove the shutter.

