﻿GET_GEVOMechL2_03_01_01_71 - STEP-BY-STEP Cont Screen
1
00:00:00,000 --> 00:00:07,417
5. Remove the outboard Victaulic couplings and disconnect the outlet pipe from the radiator bank to be removed.

2
00:00:07,417 --> 00:00:16,958
<b>Note:</b> For additional information on disassembly and removal of the Victaulic couplings, refer to the Victaulic Coupling Removal section of this module.

3
00:00:16,958 --> 00:00:23,167
6. Disconnect the short-hood vent lines of the radiator bank to be removed.

4
00:00:23,167 --> 00:00:32,583
<b>Note:</b> The air lines should be labeled before they are removed from the shutter cylinders so that they will not be reversed when re-installing the shutters.

5
00:00:32,583 --> 00:00:39,125
7. Disconnect the air lines, two per shutter, attached to the shutter cylinders.

6
00:00:39,125 --> 00:00:45,375
<b>Note:</b> All Evolution Series locomotives are not equipped with the radiator shutter assembly.

7
00:00:45,375 --> 00:00:50,292
Some, in place of the radiator shutter assembly, have a covering grate.

8
00:00:50,292 --> 00:00:58,917
For these locomotives, remove all sets of clamps, lockwashers, washers, and bolts that secure the grate to the assembly.

9
00:00:58,917 --> 00:01:10,792
8. Remove and save the hex-head bolts, washers, and lockwashers, and remove the long-hood end covers, then place the end covers in an area where they will not be damaged.

10
00:01:10,792 --> 00:01:18,542
9. Remove the two outboard Victaulic couplings to disconnect the inlet pipes from the radiator bank to be removed.

11
00:01:18,542 --> 00:01:28,583
<b>Note:</b> For additional information on disassembly and removal of the Victaulic couplings, refer to the Victaulic Coupling Removal section of this module.


