﻿1
00:00:00,000 --> 00:00:05,250
6. From the B-side (left side) of the locomotive:

2
00:00:05,250 --> 00:00:11,500
a. Disassemble and remove the couplings securing the piping to the cast WBIC.

3
00:00:11,500 --> 00:00:21,125
<b>Note:</b> For additional information on disassembly and removal of the Victaulic couplings, refer to the Victaulic Coupling Removal section of this module.

4
00:00:21,125 --> 00:00:25,875
b. Disconnect the vent fitting and discard the gaskets.

5
00:00:25,875 --> 00:00:34,333
c. Loosen and remove the 16 Allen bolts that secure the core access plate with end tank to the outer end fastening plate.

6
00:00:34,333 --> 00:00:51,208
<b>Note:</b> Depending on the cast WBIC B-side end plate design, M10 bolts either with or without hard lock (Nord-Lock) washers may have been used instead of Allen bolts to secure the core access plate with end tank to the outer end fastening plate.

7
00:00:51,208 --> 00:00:57,833
d. Set the core access plate with end tank aside and save all hardware for re-use.

8
00:00:57,833 --> 00:01:00,833
e. Discard the O-ring.

9
00:01:00,833 --> 00:01:10,583
f. Loosen and remove the 16, 1/2-inch hex bolts and washers that secure the outer end fastening plate to the intercooler shell.

10
00:01:10,583 --> 00:01:16,958
g. Remove the outer end fastening plate and save all hardware for re-use.