﻿GET_GEVOMechL2_03_01_01_85 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:04,583
Typical steps to install the radiator fan are as follows:

2
00:00:04,583 --> 00:00:15,458
<b>Warning:</b> To prevent personal injury and potential equipment damage, ensure that the engine cannot be started before removing, installing, or adjusting any components.

3
00:00:15,458 --> 00:00:18,583
Open the BS to prevent starting attempts.

4
00:00:18,583 --> 00:00:24,042
Also, place the FPB and the LCCB in the OFF position.

5
00:00:24,042 --> 00:00:27,167
Apply a warning tag to the EC switch.

6
00:00:27,167 --> 00:00:36,833
<b>Warning:</b> The radiator fan weighs approximately 1,645 lbs. (746 kg).

7
00:00:36,833 --> 00:00:39,875
Ensure that the lifting device is adequate.

8
00:00:39,875 --> 00:00:47,958
<b>Caution:</b> Use extreme care when removing the radiator fan assembly to prevent damaging the fan blades and the shroud.

9
00:00:47,958 --> 00:00:58,750
1. Place the forks of a forklift or a lifting fixture suspended from a crane into the two hollow box sections across the bottom of the radiator fan motor.

10
00:00:58,750 --> 00:01:08,500
2. Lift the fan and motor, and insert it through the opening from where the screens and shroud were removed in the side of the radiator cab structure.

11
00:01:08,500 --> 00:01:17,250
3. Lower the motor onto the support, aligning the fan and support with the mounting bolt holes in the radiator cab structure.

