﻿GET_GEVOMechL2_02_01_01_83 - STEP-BY-STEP Cont Screen
1
00:00:00,000 --> 00:00:03,750
<b>Caution: </b>Use only approved filter elements.

2
00:00:03,750 --> 00:00:10,708
Using other filter elements, such as cotton waste filters, could result in damage to critical components. 

3
00:00:10,708 --> 00:00:14,458
7. Install new approved filter elements.

4
00:00:14,458 --> 00:00:19,333
8. Ensure all filter elements are properly seated and clamped. 

5
00:00:19,333 --> 00:00:24,083
9. Inspect the filter housing door O-ring and replace if needed.

6
00:00:24,083 --> 00:00:27,833
<b>Note: </b>Ensure that the O-ring groove is wiped clean.

7
00:00:27,833 --> 00:00:31,125
Use only clean engine oil to lubricate the O-ring.

8
00:00:31,125 --> 00:00:35,625
Hold the O-ring and pull the cord between your fingers to evenly spread the lubricant.

9
00:00:35,625 --> 00:00:38,458
Do not apply any lubricant to the groove.

10
00:00:38,458 --> 00:00:46,167
10. Close the filter housing door and torque the clamping nuts in a crisscross pattern to the torque indicated on the label.

11
00:00:46,167 --> 00:00:51,958
11. Close the lubricating oil filter housing vent and drain back valves.

12
00:00:51,958 --> 00:00:58,792
<b>Note: </b>The engine cab door cannot be closed with the filter drain back valve handle in the OPEN position.

13
00:00:58,792 --> 00:01:07,417
12. If the oil filter housing was drained to the engine crankcase and the lubricating oil system was not fully drained, complete the following:

14
00:01:07,417 --> 00:01:18,958
a. Close the BS and then close the LCCB, FPB, and BCCB on the EC panel, remove the warning tag from the EC switch, and start the engine.

15
00:01:18,958 --> 00:01:28,375
b. With the engine at IDLE, check and fill the crankcase lubricating oil level as discussed in the Lubricating Oil Level Check and Fill section of this module.

16
00:01:28,375 --> 00:01:43,583
13.	If the lubricating oil system was fully drained prior to replacing the lubricating oil filter elements, fill the lubricating oil system as discussed in the fill portion of the Lubricating Oil System Drain and Initial Fill section of this module.