﻿GET_GEVOMechL2_02_01_01_78 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:05,167
Typical steps to install the lubricating oil filter housing are as follows:

2
00:00:05,167 --> 00:00:17,292
<b>Warning:</b> To prevent personal injury and potential equipment damage, ensure that the engine cannot be started before removing, installing, or adjusting any engine component.

3
00:00:17,292 --> 00:00:21,667
Place the BS in the OFF position to prevent starting attempts.

4
00:00:21,667 --> 00:00:30,958
Also, place the FPB, LCCB, and BCCB in the OFF position, and apply a warning tag on the EC switch.

5
00:00:30,958 --> 00:00:38,542
<b>Warning:</b> If the locomotive is equipped with AESS, the diesel engine may start without operator action.

6
00:00:38,542 --> 00:00:42,625
Exercise caution when working around the radiator cab.

7
00:00:42,625 --> 00:00:48,458
Ensure that AESS is disabled before performing any maintenance on the locomotive.

8
00:00:48,458 --> 00:00:53,208
Failure to do so may result in death or serious personal injury.

9
00:00:53,208 --> 00:01:01,917
<b>Warning:</b> The oil filter housing weighs approximately 760 lbs. (345 kg).

10
00:01:01,917 --> 00:01:06,792
Ensure that the lifting device, cables, and straps are adequate.

11
00:01:06,792 --> 00:01:10,708
Failure to do so may result in personal injury or death.

12
00:01:10,708 --> 00:01:16,667
1. Attach lifting slings or cables to the holes on the lubricating oil filter.

13
00:01:16,667 --> 00:01:27,958
<b>Note:</b> The oil filter housing needs to be angled using a come-along, or a similar device, to maneuver the oil filter housing past the support bar of the radiator cab.

14
00:01:27,958 --> 00:01:36,708
2. Lift the lubricating oil filter housing and manually rotate the filter housing to pass through the support bar of the radiator cab.

15
00:01:36,708 --> 00:01:45,542
3. Place the oil filter housing on the radiator cab floor and gently slide it through the radiator cab to the mounting location.

16
00:01:45,542 --> 00:02:03,417
4. Install the ten mounting bolts that secure the filter housing to the floor of the radiator cab, then torque the bolts to 105-115 lb.-ft. (142-156 Nm) in a crisscross pattern.

17
00:02:03,417 --> 00:02:08,792
5. Connect the oil cooler to the oil filter housing as follows:

18
00:02:08,792 --> 00:02:21,875
a. Remove the plugs and unblock all flange and pipe openings, then reconnect the oil filter housing drain back valve drain flange and drain piping assembly and install the previously removed hardware.

19
00:02:21,875 --> 00:02:33,500
b. Remove the plugs and unblock all flange and pipe openings, then reconnect the pipe sections on the back of the oil filter housing and install the previously removed hardware.

20
00:02:33,500 --> 00:02:43,875
c. Remove the blanking plate and plugs and then reconnect the piping connecting the oil cooler to the oil filter housing and install the previously removed hardware.
