﻿GET_GEVOMechL2_02_01_01_75 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:05,167
Typical steps to remove the lubricating oil filter housing are as follows: 

2
00:00:05,167 --> 00:00:17,292
<b>Warning: </b>To prevent personal injury and potential equipment damage, ensure that the engine cannot be started before removing, installing, or adjusting any engine component. 

3
00:00:17,292 --> 00:00:21,667
Place the BS in the OFF position to prevent starting attempts. 

4
00:00:21,667 --> 00:00:30,958
Also, place the FPB, LCCB, and BCCB in the OFF position, and apply a warning tag on the EC switch. 

5
00:00:30,958 --> 00:00:38,542
<b>Warning: </b>If the locomotive is equipped with AESS, the diesel engine may start without operator action. 

6
00:00:38,542 --> 00:00:42,625
Exercise caution when working around the radiator cab. 

7
00:00:42,625 --> 00:00:48,458
Ensure that AESS is disabled before performing any maintenance on the locomotive. 

8
00:00:48,458 --> 00:00:53,333
Failure to do so may result in death or serious personal injury. 

9
00:00:53,333 --> 00:00:59,292
1. Drain the oil from the lubricating oil filter housing as follows: 

10
00:00:59,292 --> 00:01:06,542
a. Open the lubricating oil filter housing vent valve on the inlet pipe to the oil filter housing. 

11
00:01:06,542 --> 00:01:14,250
b. Open the lubricating oil filter drain back valve to allow the oil to drain to the engine crankcase. 

12
00:01:14,250 --> 00:01:17,958
<b>Note: </b>Allow 15 minutes for the hot oil to drain. 

13
00:01:17,958 --> 00:01:21,708
If the oil is cold, draining takes much longer. 

14
00:01:21,708 --> 00:01:28,542
<b>Warning: </b>Ensure that oil from the system has completely cooled before any maintenance is performed. 

15
00:01:28,542 --> 00:01:37,583
Lubricating oil filter housing replacement includes steps in which the oil cooler connections must be covered with blanking plates or plugged. 

16
00:01:37,583 --> 00:01:43,500
Failure to allow the oil to cool could result in serious burns and personal injury. 

17
00:01:43,500 --> 00:01:50,375
2. Remove the applicable locomotive handrail section to allow for oil filter housing removal.
