﻿GET_GEVOMechL2_02_01_01_71 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:04,667
Typical steps to install the lubricating oil cooler are as follows:

2
00:00:04,667 --> 00:00:16,792
<b>Warning:</b> To prevent personal injury and potential equipment damage, ensure that the engine cannot be started before removing, installing, or adjusting any engine component.

3
00:00:16,792 --> 00:00:21,208
Place the BS in the OFF position to prevent starting attempts.

4
00:00:21,208 --> 00:00:30,583
Also, place the FPB, LCCB, and BCCB in the OFF position, and apply a warning tag on the EC switch.

5
00:00:30,583 --> 00:00:38,083
<b>Warning:</b> If the locomotive is equipped with AESS, the diesel engine may start without operator action.

6
00:00:38,083 --> 00:00:42,208
Exercise caution when working around the radiator cab.

7
00:00:42,208 --> 00:00:48,000
Ensure that AESS is disabled before performing any maintenance on the locomotive.

8
00:00:48,000 --> 00:00:53,208
Failure to do so may result in death or serious personal injury.

9
00:00:53,208 --> 00:01:00,833
<b>Warning:</b> The oil cooler weighs approximately 820 lbs. (372 kg).

10
00:01:00,833 --> 00:01:05,792
Ensure the lifting device, cables, and straps used are adequate.

11
00:01:05,792 --> 00:01:09,958
Failure to do so may result in personal injury or death.

12
00:01:09,958 --> 00:01:16,167
1. Attach lifting slings or cables to the holes of the lubricating oil cooler.

13
00:01:16,167 --> 00:01:26,458
<b>Note:</b> The oil cooler needs to be angled using a come-along, or a similar device, to maneuver the oil cooler past the support bar of the radiator cab.

14
00:01:26,458 --> 00:01:35,167
2. Lift the lubricating oil cooler and manually rotate the lubricating oil cooler to pass through the support bar of the radiator cab.

15
00:01:35,167 --> 00:01:44,000
3. Place the lubricating oil cooler on the radiator cab floor and gently slide it through the radiator cab to the mounting location.

16
00:01:44,000 --> 00:02:00,625
4. Install the four mounting bolts securing the oil cooler to the floor of the radiator cab, then torque the bolts to 200-220 lb.-ft. (271-298 Nm) in a crisscross pattern.

17
00:02:00,625 --> 00:02:10,000
5. Remove the plugs from the fuel hose openings, then re-install the fuel hoses and secure with the previously removed clamps.

18
00:02:10,000 --> 00:02:20,583
6. Remove the plugs from the water pipe openings, then reconnect the two water pipes to the lubricating oil cooler and secure with the previously removed couplings.

19
00:02:20,583 --> 00:02:29,875
<b>Note:</b> For complete information on removal and installation of the couplings, refer to the Victaulic Couplings Removal and Installation sections of this module.
