﻿GET_GEVOMechL2_02_01_01_107 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:04,542
Typical steps to remove the coalescer eductor tube are as follows: 

2
00:00:04,542 --> 00:00:16,875
<b>Warning: </b>To prevent personal injury and potential equipment damage, ensure that the engine cannot be started before removing, installing, or adjusting any engine component. 

3
00:00:16,875 --> 00:00:21,375
Place the BS in the OFF position to prevent starting attempts. 

4
00:00:21,375 --> 00:00:30,583
Also, place the FPB, LCCB, and BCCB in the OFF position, and apply a warning tag on the EC switch. 

5
00:00:30,583 --> 00:00:38,042
<b>Warning: </b>If the locomotive is equipped with AESS, the diesel engine may start without operator action. 

6
00:00:38,042 --> 00:00:42,125
Exercise caution when working around the radiator cab. 

7
00:00:42,125 --> 00:00:47,958
Ensure that AESS is disabled before performing any maintenance on the locomotive. 

8
00:00:47,958 --> 00:00:53,083
Failure to do so may result in death or serious personal injury. 

9
00:00:53,083 --> 00:00:59,042
<b>Warning: </b>Do not remove the eductor while the engine is running or hot. 

10
00:00:59,042 --> 00:01:08,417
1. Remove the upper coalescer hose from the eductor tube, as discussed in the Coalescer Hose Removal section of this module. 

11
00:01:08,417 --> 00:01:13,583
2. Remove the steel braided hose from the fitting on the eductor tube. 

12
00:01:13,583 --> 00:01:18,542
<b>Note: </b>Do not remove the straight fitting installed in the eductor. 

13
00:01:18,542 --> 00:01:25,750
3. Remove the eductor tube and the eductor gasket by removing the eductor tube mounting bolts. 

14
00:01:25,750 --> 00:01:33,125
<b>Note: </b>Once the eductor is removed, the eductor gasket and doughnut seal should also be replaced. 

15
00:01:33,125 --> 00:01:40,833
4. Scrap the removed eductor gasket and save the mounting bolts and washers for reuse. 

16
00:01:40,833 --> 00:01:46,500
5. Remove the eductor bracket front bolts and spacers.
