﻿GET_GEVOMechL2_02_01_01_102 - STEP-BY-STEP Screen
1
00:00:00,000 --> 00:00:03,875
Typical steps to remove the coalescer are as follows: 

2
00:00:03,875 --> 00:00:16,125
<b>Warning: </b>To prevent personal injury and potential equipment damage, ensure that the engine cannot be started before removing, installing, or adjusting any engine component. 

3
00:00:16,125 --> 00:00:20,375
Place the BS in the OFF position to prevent starting attempts. 

4
00:00:20,375 --> 00:00:29,958
Also, place the FPB, LCCB, and BCCB in the OFF position, and apply a warning tag on the EC switch. 

5
00:00:29,958 --> 00:00:37,250
<b>Warning: </b>If the locomotive is equipped with AESS, the diesel engine may start without operator action. 

6
00:00:37,250 --> 00:00:41,333
Exercise caution when working around the radiator cab. 

7
00:00:41,333 --> 00:00:47,167
Ensure that AESS is disabled before performing any maintenance on the locomotive. 

8
00:00:47,167 --> 00:00:52,167
Failure to do so may result in death or serious personal injury. 

9
00:00:52,167 --> 00:00:59,458
<b>Note: </b>Before the coalescer can be removed from the engine, all coalescer hoses must be disconnected. 

10
00:00:59,458 --> 00:01:05,292
<b>Warning: </b>Do not remove the coalescer hoses while the engine is running or hot. 

11
00:01:05,292 --> 00:01:14,167
1. Remove the upper and lower coalescer hoses as discussed in the Coalescer Hose Removal section of this module. 

12
00:01:14,167 --> 00:01:18,083
2. Disconnect the coalescer drain line. 

13
00:01:18,083 --> 00:01:22,917
3. Support the coalescer to prevent it from falling. 

14
00:01:22,917 --> 00:01:28,667
4. Remove the retaining strap bolts from the retaining straps. 

15
00:01:28,667 --> 00:01:33,500
5. Remove the coalescer from its installed position.
